目标达成 感谢每一位支持者 — 我们达成了 100% 目标!

目标: 1000 元 · 已筹: 1359 元

100%

CVE-2026-93669— ITE IT8xxx2 SHI后端空指针解引用漏洞

一分钟漏洞结论

影响对象
zephyrproject zephyr
利用判断
尚无明确在野利用证据,仍需结合暴露面评估
建议动作
优先检查厂商安全公告和参考链接中的修复版本;无法立即升级时,限制受影响服务暴露并加强监测。

ITE IT8xxx2 SHI 主机命令后端(位于 )在接收上下文尚未创建之前便启用了 SPI 外设。具体而言, 函数在设备以 优先级(默认值为 ,即 40)初始化时,将状态机设置为 并调用 ;然而, 和 直到后续由 调用的 (默认优先级为 ,即 80)中才被赋值。 如果在此期间连接的主机处理器发起 SPI 事务,Rx-valid-length(接收有效长度)中断将触发。 通过状态检查后调用 ,该函数尝试将源自主机的请求长度存储到仍为 NULL 的 中。在 IT8xxx2 上,低地址区域并未由 RAM 支持;且当启

CVSS 4.7 · Medium

可能的 ATT&CK 技术 1 AI

T1499 · Endpoint Denial of Service
获取后续新漏洞提醒 登录后订阅

一、 漏洞 CVE-2026-93669 基础信息

漏洞信息

对漏洞内容有疑问?看看神龙的深度分析是否有帮助!
查看神龙十问 ↗

尽管我们使用了先进的大模型技术,但其输出仍可能包含不准确或过时的信息。神龙努力确保数据的准确性,但请您根据实际情况进行核实和判断。

Vulnerability Title
NULL pointer dereference in the ITE IT8xxx2 SHI host-command backend when a host transaction arrives before backend initialization
来源: CVE Program / CVE List V5
Vulnerability Description
The ITE IT8xxx2 SHI host-command backend in subsys/mgmt/ec_host_cmd/backends/ec_host_cmd_backend_shi_ite.c arms the SPI peripheral before its receive context exists. shi_ite_init_registers() sets the state machine to SHI_STATE_READY_TO_RECV and calls irq_enable() while the device initializes at POST_KERNEL priority CONFIG_KERNEL_INIT_PRIORITY_DEFAULT (40), but data->rx_ctx and data->tx are only assigned later by shi_ite_backend_init(), which ec_host_cmd_init() invokes at CONFIG_EC_HOST_CMD_INIT_PRIORITY (default 80). If the attached host processor starts a SPI transaction inside that window, the Rx-valid-length interrupt fires, shi_ite_int_handler() passes its state check and calls shi_ite_parse_header(), which stores the host-derived request length through the still-NULL data->rx_ctx. On the IT8xxx2 low addresses are not backed by RAM, and with CONFIG_NULL_POINTER_EXCEPTION_DETECTION_PMP the first bytes of the address space are explicitly made inaccessible, so the store raises a fatal access fault in interrupt context. The window widens further when CONFIG_EC_HOST_CMD_INITIALIZE_AT_BOOT is disabled and the application calls ec_host_cmd_init() itself. The result is a kernel panic on the embedded controller: with Zephyr's default fatal handler the CPU halts, so the controller stops servicing host commands until a hardware reset. Because the trigger is traffic from the attached host processor -- an untrusted peer from the controller firmware's point of view -- software on that host can provoke the fault by forcing a controller reset and issuing transactions during the reboot, turning a recoverable reset into a persistent outage. Impact is limited to availability: the faulting address is fixed and not attacker-chosen, so no memory-corruption primitive follows. The fix leaves the interface at SHI_STATE_DISABLED with the interrupt masked during device init, moves irq_enable() into shi_ite_backend_init() after the buffers are published, and makes shi_ite_int_handler() reject a NULL data->rx_ctx while write-clearing IT83XX_SPI_ISR and IT83XX_SPI_RX_VLISR so that an unexpected early interrupt cannot storm.
来源: CVE Program / CVE List V5
CVSS Information
CVSS:3.1/AV:L/AC:H/PR:L/UI:N/S:U/C:N/I:N/A:H
来源: CVE Program / CVE List V5
Vulnerability Type
空指针解引用
来源: CVE Program / CVE List V5

受影响产品

厂商 产品 影响版本 CPE 订阅
zephyrproject zephyr 3.4.0 ~ 4.3.2 -

二、漏洞 CVE-2026-93669 的公开POC

# POC 描述 源链接 神龙链接
AI 生成 POC 高级

未找到公开 POC。

登录以生成 AI POC

三、漏洞 CVE-2026-93669 的情报信息

请登录查看更多情报信息。

CVE-2026-93669 其他参考 (2)

同批安全公告 · zephyrproject · 2026-11-16 · 共 8 条

CVE-2026-93668 6.5 MEDIUM Linux 蓝牙SDP服务器拒绝服务漏洞
CVE-2026-93667 5.9 MEDIUM Zephyr Virtual L2 VLAN帧处理类型混淆漏洞
CVE-2026-93666 5.3 MEDIUM 蓝牙经典SDP客户端缓冲区分配死锁漏洞
CVE-2026-93672 5.3 MEDIUM Linux 蓝牙 ATT 请求查找空指针解引用漏洞
CVE-2026-93673 4.8 MEDIUM WebSocket客户端握手验证缺失漏洞
CVE-2026-93671 3.7 LOW Zephyr WebSocket客户端越界读取漏洞
CVE-2026-93670 3.5 LOW DesignWare I3C驱动越界写漏洞

IV. Related Vulnerabilities